How to Set up a new cordless phone

How to Set up a new cordless phone

Registering extensions to a Yealink device is done via the Web Interface of the Yealink IP Phone.

  1. Log into the handset by opening a new tab in your Web Browser and inserting the phone’s IP Address into the Address bar. ( Press the OK button to get the IP address.)
  2. Go to Account; this is where we enter the extension’s details. How to Get Sip Credentials.
  3. Log into the Yealink account by inserting the IP address in a web browser.
    Note: To log into the device, the user will need the IP address. (Refer to the device configuration manual.)
  4. Click on the Account tab and fill in the information. 
  5. Click on Apply - the extension should say registered.
  6. Enable the correct audio codecs. ( Euphoria uses the G729 Codec.)
    1. Remove unnecessary Codecs by holding the Shift key on the keyboard and select all unwanted Codecs.
    2. Click on the arrow facing towards the Disabled Codecs block. Click Confirm. 
  7. Enter the voicemail code, *85, in the advanced section of the account
  8. Click on the Account tab again. Change the account number to another account by selecting it from the drop-down menu.
  9. Repeat steps 6 to 7 in order to configure the new account with another extension that a handset could pair to.
  10. Ensure Time& Date settings are correct. Euphoria has its own time servers, ntp1.euphoria.co.za andNTP.euphoria.co.za.
    1. Insert ntp1.euphoria.co.za.
    2. If a secondary NTP Server is required, insert NTP.euphoria.co.za.
    3. Choose the correct time zone (+2 Greece, Israel, Turkey etc. )
    4. Disable Daylight Saving Time.
    5. Save the changes and click Confirm.
  11. Click on the Features tab and select the General Information sub-menu
    1. Enable the Accept SIP Trust Server Only option.
    2. Change the Number of Active Handsets to 8.

    • Related Articles

    • Setup of a Gigaset Phone

      Register an extension to a Gigaset device via the Web Interface of the Gigaset IP Phone. Log into the handset - Openithe Gigaset Browser and insert the IP Address. (By default, the phone is set on DHCP, to get the IP address, you would need to press ...

    • Setup of a Fanvil Phone

      Connect the Fanvil device to the network (modem/router/switch/network point) using an Ethernet cable (ensure the PC is connected to the same network as the Fanvil device) Locate the IP address OnFanvil X3SP Press the "OK" button on Fanvil X3SP or ...

    • Setting up a Yealink Phone

      Registering extensions to a Yealink device is done via the Web Interface of the Yealink IP Phone. Log on to the handset by opening a new tab in your Web Browser and inserting the phone’s IP Address into the Address bar. ( Press the OK button to get ...

    • Setup Agent Login for the Yealink Phone.

      Log into the Yealink account by inserting the IP address in a web browser. Note: To log into the device, the user will need the IP address (Refer to the devices configuration manual.) Set up the Dsskeys. Ensure the log on/off buttons (Label) are ...

    • How to Make a Network Change on the SNOM Phone.

      Navigate to the advanced options on the left and on the network tab. Fill in the NTP time server as above and the time zone ( +2 ). To set the phone on static, make sure the DHCP is turned off and the following filled in: Ip address : Netmask : IP ...