Troubleshooting: Vibe router not up, But showing that its up. Phones are showing no service through vibe but not when you bypass it.

Troubleshooting: Vibe router not up, But showing that its up. Phones are showing no service through vibe but not when you bypass it.

The head end might have cached information and when we remove the head end info and apply settings then re-add the info the link comes up.

    • Related Articles

    • Troubleshooting: Phones/Vibe/Networking

      Checklist for Phones Is the phone connected to the correct port (Internet port on Yealink desk phones)? Has a different network cable been tried? Has a different power supply of a working phone been tried? Is the phone on the correct network? (DHCP/ ...

    • Troubleshooting Guide

      Introduction This guide has been created to help with the troubleshooting process and to ensure the most common issues/checks have been addressed. Troubleshooting - Phones/Vibe/Networking Checklist for Phones Is the phone connected to the correct ...

    • Troubleshooting: Calls Dropping using a Mikrotik OS. (Router)

      We have seen a SIP helper cause occasional dropped calls when using a Mikrotik Router without ViBE. Go to Firewall Settings. Go to Service Ports. Ensure sip on port 5060 and 5061 option is disabled. When you mouse rolls over it, it will give you the ...

    • Troubleshooting: Vibe Headend Entry highlighted in Red

      1. If it shows the Mac address, either the Vibe CPE is not connected correctly to the network, or the Firewall is blocking the VPN from exiting the network 2. If it shows the IP address, Packets are being sent to the VIBE server but are not able to ...

    • Troubleshooting: Issues with an Asterisk Installation with SIP Trunk behind a Sonicwall TZ100 Router.

      The problem usually is the one-way communication router through one trunk or another related issue.To solve the issue there are the general rules: 1. Set the UDP timeout to 90 sec or more. 2. Do not use SIP transformations (Voip section) and modify ...