Setting up a SNOM Phone

Setting up a SNOM Phone

  1.  Connect the SNOM to the network and let it get an IP Address.

  2.  Log on to the device’s web interface.

  3.  Click on the  Identity 1 option on the left under the Setup category.

  4.  The page will open on the “ Login” tab; fill in the SIP credentials. 

    1. This will allow the extension to register.

  5.  Next, navigate to the RTP tab (Still under the Identity section) and make sure the settings are set like the image below :

    1. Codec: g729

    2. RTP encryption: Off

    3. Media transport offer: UDP

  6.  Select System Information to confirm Identity 1 is online.

  7.  Navigate to the Advanced section on the left.

  8.  Choose Behavior.

  9.  Disable Challenge- Response.

    • Related Articles

    • Setting up a Yealink Phone

      Registering extensions to a Yealink device is done via the Web Interface of the Yealink IP Phone. Log on to the handset by opening a new tab in your Web Browser and inserting the phone’s IP Address into the Address bar. ( Press the OK button to get ...

    • How to Make a Network Change on the SNOM Phone.

      Navigate to the advanced options on the left and on the network tab. Fill in the NTP time server as above and the time zone ( +2 ). To set the phone on static, make sure the DHCP is turned off and the following filled in: Ip address : Netmask : IP ...

    • Setup of a Gigaset Phone

      Register an extension to a Gigaset device via the Web Interface of the Gigaset IP Phone. Log into the handset - Openithe Gigaset Browser and insert the IP Address. (By default, the phone is set on DHCP, to get the IP address, you would need to press ...

    • Setup of a Fanvil Phone

      Connect the Fanvil device to the network (modem/router/switch/network point) using an Ethernet cable (ensure the PC is connected to the same network as the Fanvil device) Locate the IP address OnFanvil X3SP Press the "OK" button on Fanvil X3SP or ...

    • Setup Agent Login for the Yealink Phone.

      Log into the Yealink account by inserting the IP address in a web browser. Note: To log into the device, the user will need the IP address (Refer to the devices configuration manual.) Set up the Dsskeys. Ensure the log on/off buttons (Label) are ...