Calls dropping using a the Mikrotik OS (Router)

Calls dropping using a the Mikrotik OS (Router)

We have seen a SIP helper cause occasional dropped calls when using a Mikrotik Router without ViBE.


1. Go to Firewall Settings

2. Go to Service Ports

3. Ensure sip on port 5060 and 5061 option is disabled.

4. When you mouse rolls over it, it will give you the option to enable, as it is disabled


Euphoria Telecom

    • Related Articles

    • I use an 086 number, and I am not receiving any inbound calls.

      In this scenario, it is most likely that there is a problem with your Smart Call account with Telkom. Some reasons could be: Overdue account. Telkom has a routing issue, so the calls are not reaching your Cloud PBX. This would need to be resolved by ...

    • Vibe router not up but showing that its up but its not up and phones are showing no service through vibe but not when you bypass it

      The head end might have cached information and when we remove the head end info and apply settings then re-add the info the link comes up

    • Euphoria Hardware Options

      Desk Phones Yealink Executive T31P Compatible with Yealink YHS34 Headset Requires Yealink Mono Power Supply Backlit LCD Screen Up to 3 VoIP accounts* Hold, Transfer, Redial Buttons 3-way conference ability Built-in Speakerphone Power over Ethernet ...

    • 1MB Line works better than, e.g. 2MB Line

      When using VOIP, it is recommended to be on a 1MB ADSL line rather than, for example, a 2MB or 10MB line. The reason for this being that the smaller line is more synchronised with regards to uploading speed& downloading speed.e.g. When using a 1MB ...

    • Setup of a Fanvil Phone

      Connect the Fanvil device to the network (modem/router/switch/network point) using an Ethernet cable (ensure the PC is connected to the same network as the Fanvil device) Locate the IP address OnFanvil X3SP Press the "OK" button on Fanvil X3SP or ...